M600 refuses to work? Dual extruder issue - Snapmaker 2.0
Por um escritor misterioso
Descrição
So, I’m trying to pause my print to inlay a laser engraving. I can not for the life of me get M600 to work for some reason. I’m printing solely with Extruder 2(T1) and every which way I enter the M600 command, it just skips right past it. Not sure what I might be doing wrong. These are the methods I’ve tried; M600 T1; T1 M600; T1; M600; T0 M600;(interestingly, this switches to Extruder 1(T0) and then proceeds through the print as if M600 was not there at all. I believe I’ve also tried str
J1 Community FAQs - Snapmaker J1 - Snapmaker: where creation happens
Pause and Place Things in 3D Prints (Cura)
Instructions, Embedding a mesh into 3D print
Insert pause or custom G-code at layer
Linear Advance Factor
Mintion, Beagle V2 Camera
Dual extruder warning - Snapmaker 2.0 - Snapmaker: where creation
Snapmaker Dual Extruder Module - Failure to Feed
Dual extruder stops to extrude - Snapmaker 2.0 - Snapmaker: where
