How to get inverse fill to follow outline without waste - Getting Started With LightBurn - LightBurn Software Forum
Por um escritor misterioso
Descrição
I have an fill layer I am trying to reverse I know i can put a box around it and get this Which does put most of the fill where i want it but it does not follow the cut outs of the original edges and it also has a ton of fill that is just a complete waste of time. Is there a way to get the fill i want to follow the edges with the tabs and not have so much fill where its not needed. Here is the file UR_Box.lbrn2 (597.5 KB)
Fill and Line too strong? - LightBurn Software Questions - LightBurn Software Forum
How to get inverse fill to follow outline without waste - Getting Started With LightBurn - LightBurn Software Forum
Setting a section to *not* fill - LightBurn Software Questions - LightBurn Software Forum
Concentric Line Fill Possible? - LightBurn Software Questions - LightBurn Software Forum
How to get inverse fill to follow outline without waste - Getting Started With LightBurn - LightBurn Software Forum
Reverse Burn Logo - LightBurn Software Questions - LightBurn Software Forum
How do I invert (negate) a vector engraving? - Resources - LightBurn Software Forum
Invert Engrave or Fill - LightBurn Software Questions - LightBurn Software Forum
Fill instead of clear area - LightBurn Software Questions - LightBurn Software Forum
Heaven: God's Highest HopeMax Lucado Violence Is Golden - A Mike Shayne Novel
