Temperature Drops after Print Starts - AO-101 & AO-100 - LulzBot
Por um escritor misterioso
Descrição
Hey Guys, So I had to put in new thermistor recently, did some other structural changes (60mm height increase) and wired in a fan which isn’t currently connected. Yet now I am getting this issue with my hotend where once the print start the temperature drops even though it looks like the extruder is still rocking it. I ran PID autotune, stored the values, brought the bed and then the hotend up too 230C using Repetier. Then I dropped in the GCODE. You can see down below the temperature curve. T
Arduino « Midsouth Makers – Memphis Area Makerspace
A digital twin ecosystem for additive manufacturing using a real-time development platform
High-performance polymer 3D printing – Open-source liquid cooled scalable printer design - ScienceDirect
Technologies, Free Full-Text
Hot End Melted Itself - AO-101 & AO-100 - LulzBot
TweakTown's Guide to 3D Printing: Part 1 - What makes up a 3D Printer?
3D Printing Troubleshooting Guide
Multi‐Material 3D and 4D Printing: A Survey - Rafiee - 2020 - Advanced Science - Wiley Online Library
LulzBot Mini 2 Review
TweakTown's Guide to 3D Printing: Part 1 - What makes up a 3D Printer?
Introduction to Low-Cost 3D Printing
